|Gaoxin Industrial Park,Guangming New Zone,Shenzhen City, Guangdong Province, China||Angelwang66@126.com|
|Place of Origin:||China|
|Minimum Order Quantity:||10 PCS|
|Packaging Details:||SIPDIP PACKING|
|Delivery Time:||2 WORKDAYS|
FIXED INPUT, ISOLATED & UNREGULATED DUAL OUTPUT DC-DC CONVERTER ExxxxS/D-xW SERIES 1W ～2W SIP/DIP PACKAGE
● Small size,low cost
● SIP/DIP Package
● Low Ripple and good EMC features
● Temperature Range: -40°C ~ +85°C
● No External Component Required
● 3KVDC Isolation
● Continuous Short Circuit Protection
● Internal SMD construction
● Industry Standard Pinout
ExxxxS/D-xW Series are specially designed for applications where a single power supply is highly isolated from the
input power supply in a distributed power supply system on a circuit board.
These products apply to:
1, Where the power supply system distribution , the digital circuit isolation and voltage conversion
2, Where the security equipment, broadcasting equipment, power supply, isolation and voltage conversion
3, Where the voltage of the input power supply is fixed (voltage variation ≤±10%)
4, Where isolation is necessary between input and output (isolation voltage ≤3000VDC);
5, Where the regulation of the output voltage and the output ripple and noise are demanded.
① Requirement on output load
To ensure this module can operate efficiently and reliably, During operation, the
minimum output load could not be less than 10% of the full load. If the actual output
power is very small, please connect a resistor with proper resistance at the output end in
parallel to increase the load, or use our company’s products with a lower rated output
power (IB_LD -W25/IB_LS-W25 series).
② Recommended testing and application circuit
If you want to further decrease the input/output ripple, an “LC” filtering network may be
connected to the input and output ends of the DC/DC converter, see (Figure 1)
It should also be noted that the inductance and the frequency of the “LC” filtering
network should be staggered with the DC/DC frequency to avoid mutual interference.
However, the capacitance of the output filter capacitor must be proper. If the capacitance
is too big, a startup problem might arise. For every channel of output, provided the safe
and reliable operation is ensured, the greatest capacitance of its filter capacitor sees
③ Overload Protection
Under normal operating conditions, the output circuit of these products has no
protection against over-current. The simplest method is to connect a self-recovery fuse in
series at the input end or add a circuit breaker to the circuit.(Figure 2)
④ Input Over-voltage Protection Circuit
The simplest device for input over-voltage protection is a linear voltage regulator with
overheat protection that is connected to the input end in series .
⑤ No parallel connection or plug and play
1. Operation under minimum load will not damage the converter; However, they may not meet all specification listed, and that will reduce the life
2. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
3. Only typical models listed, other models may be different, please contact our technical person for more details.
4. In this datasheet, all the test methods of indications are based on corporate standards.